Castle
Water Plug

“Instant Leakage Solution”

Water Plug is supplied as a ready to use blend of dry powders which requires only the site addition of clean water to produce a highly consistent, rapid setting mortar which is easy to apply in many difficult conditions. The material is based on a blend of cement, graded aggregates, special fillers and chemical additives which control the rate of set and minimize the risk of thermal cracking.

Water Plug provides an initial set time of approximately Two minute.

Product Details

Castle Water Plug is supplied as a ready to use blend of dry powders which requires only the site addition of clean water to produce a highly consistent, rapid setting mortar which is easy to apply in many difficult conditions.

USES & APPLICATIONS

  • Water Plug can be applied to horizontal, vertical or overhead surface at a wide range of thickness. Generally, the volume of mixed material used in a single application is restricted to that which can be applied by trowel or gloved hand. Thicker sections can be built up in layers. Any hole where water is leaking.

Features
Description
Product Type
Powder
Packaging
Available in 20Kg, 5Kg, and 1Kg
Shelf Life
12 Months from the date of manufacturing
Storage
Store in a dry place away from moisture

Advantages of Water Plug

ADVANTAGES OF WATER PLUG

  • Emergency water-stopping

  • Contains no chloride admixture

  • Excellent bond to the substrate

  • Low exotherm minimizes thermal cracking

  • Pre-bagged formulation to overcome variations in site batching

  • Single component – only the addition of clean water is required

PREPARE

  • Areas to be patched should be cut back to a depth of 15mm and given a good mechanical key. Feather edges must not be allowed. Surface should be brushed clean to remove loose material, dust and laitance. Grease, slime or mould growth should be removed by steam cleaning or high pressure water jetting. A proprietary degreasing agent should be used for removal of light oil or grease contamination. To seal leaks, crack openings must be chased out to approximately 20mm. The chase should always be undercut to avoid leaving a V-section. All loose material and debris should be removed.

APPLY

  • Water Plug should be added to clean water in proportions of One part clean water : 3 parts water Plug mix to a suitable container using Hand or gloved hand. Due to the rapid set characteristics of the product, only prepare a small quantity of plug which can be placed within the prescribed set time.

How to
Prepare & Apply